Revision as of 01:01, 31 August 2024

Introduction

This is a complete guide on installing NixOs, using flakes and home-manager.

Be sure to have an ISO image of NixOS, which can be obtained here: https://nixos.org/download/#nixos-iso.

Installation guide

Partitioning your disk

Open a terminal.
Wipe your disk: $ blkdiscard /dev/<installation disk>.
Create root and boot partitions:

Use parted

$ parted <installation disk>
(parted) mklabel gpt

Boot partition

(parted) mkpart
(parted) Partitoin name? boot
(parted) File system type? fat32
(parted) Start? 0%
(parted) End? 2GB
(parted) set 1 esp on
(parted) set 1 boot on

Root partition

(parted) mkpart
(parted) Partitoin name? root
(parted) File system type? btrfs
(parted) Start? 2GB
(parted) End? 100%
(parted) quit

Configure and mount partitions

$ mkfs.btrfs /dev/<root partition>
$ mkfs.vfat -F32 /dev/<boot partition>
$ mount /dev/<root partition> /mnt
$ mkdir /mnt/boot
$ mount /dev/<boot partition> /mnt/boot

Generate and edit config

$ sudo nixos-generate-config --root /mnt
Edit your configuration: $ nvim /mnt/etc/nixos/configuration.nix
Checkout your hardware config: $ nvim /mnt/etc/nixos/hardware-configuration.nix
Remember to add the following to configuration.nix so that grub works with EFI:

boot.loader.grub.enable = true;
boot.loader.grub.efiSupport = true;
boot.loader.grub.device = "nodev";
boot.loader.efi.canTouchEfiVariables = true;

Install

$ sudo nixos-install
Set root password when prompted to do so.
Reboot your machine
Login as root and set a password for your user: $ passwd <username>
Logout and login as your user

Enable flakes and replace your config with your flake

Flake

$ mkdir nix
Create your $ vim flake.nix
$ nixos rebuidl switch

Home manager

$ nix repl .

home = homeConfigurations.<configuration name>
home.activationPackage

Copy the resulting path and do:
$ build <path>
./result/activate

@@ Line 2: / Line 2: @@
 = Introduction =
-This is a complete guide on installing NixOs, using flakes.
+This is a complete guide on installing NixOs, using flakes and home-manager.
 Be sure to have an ISO image of NixOS, which can be obtained here: https://nixos.org/download/#nixos-iso.
@@ Line 64: / Line 64: @@
 = Enable flakes and replace your config with your flake =
+==== Flake ====
+# {{ic|$ mkdir nix}}
+# Create your {{ic|$ vim flake.nix}}
+# {{ic|$ nixos rebuidl switch}}
+==== Home manager ====
+# {{ic|$ nix repl .}}
+<pre>
+home = homeConfigurations.<configuration name>
+home.activationPackage
+</pre>
+# Copy the resulting path and do:
+# {{ic|$ build <path>}}
+# ./result/activate